NEWS

Your Current Location：Home > NEWS > Industry News >

THE SMART GUIDE TO MANGANESE AND HIGH CHROME CASTINGS

VIEWS: times Release Date：2016-11-26

Introduction： Castings with any of these manganese percentages could be the right ones for your application. It just depends on what you’re crushing. While you could use a higher percentage of manganese for cones or jaws, 14% manganese can work fine for hard non-abrasi

Practically every crushing operation these days is looking for ways to cut costs and increase production. One way you can find a lot of potential savings is by carefully choosing the right manganese castings. Look closely at your entire crushing operation from start to finish: the material you’re crushing, the type of crusher you’re using. Give extra attention to the profile of the crushing parts. By matching the profile of the manganese part to your operation’s requirements, you can run more efficiently with less downtime and lower operating and maintenance costs.

Here’s a list of factors to consider before you buy manganese castings. Asking the right questions before buying can save you money now and lower-costs of future operations. Manganese content is critical to the wear life of your crusher parts and the cost efficiency of your operation.

Manganese content can range between 9% - 24% and is usually referenced as;

14% = 13-14% MN

18% = 17% - 19% MN

21% = 21% - 24% MN

Castings with any of these manganese percentages could be the right ones for your application. It just depends on what you’re crushing. While you could use a higher percentage of manganese for cones or jaws, 14% manganese can work fine for hard non-abrasive materials especially with Wear and spare parts heavy duty Jaws. Remember manganese must “work-harden” for optimum performance, which should be matched with material hardness. The hardness & abrasiveness of the rock to be crushed should determine the manganese content for your operation.

Previous：we provide the very highest quality crusher wear parts Next：bowl liner

OTHERS FOLLOW

crusher replacement parts manufacturers...2018-07-25
1214,1315 counterattack broken boards hammer models...2016-08-23
Universal jaw crusher parts...2017-04-20
Gyratory Crusher Mantles Suppliers...2018-07-25
China Mining Crusher Wear Parts Manufacturer...2016-12-30
High Manganese Steel Wear Parts Manufacturers...2017-01-04

Hot Products

News

Contact Us

Tel：+86 0717-3286139
Phone：+8618872506886
Fax：+86 0717-3286139
Mail：vip@jinyangshi.com
Website：http://www.jinyangshi.net
Address：East 15 Jinping Avenue,Dangyang,Hubei Province,China

NEWS

THE SMART GUIDE TO MANGANESE AND HIGH CHROME CASTINGS

OTHERS FOLLOW

RELATED READING

MESSAGE

Hot Products

News

Contact Us

Wear parts

Casting Material

Casting Technology

Solutions

About JYS

MESSAGE